Add HP Elitedesk 800 G2 SFF to list.

Bad news, you have a `Q170 Chipset LPC/eSPI Controller` so you have ME hardware on board and you can't control or disable it, continuing... MEI found: [8086:a13a] 100 Series/C230 Series Chipset Family MEI Controller #1 ME Status : 0x90000245 ME Status 2 : 0x89108106 ME: FW Partition Table : OK ME: Bringup Loader Failure : NO ME: Firmware Init Complete : YES ME: Manufacturing Mode : NO ME: Boot Options Present : NO ME: Update In Progress : NO ME: Current Working State : Normal ME: Current Operation State : M0 with UMA ME: Current Operation Mode : Normal ME: Error Code : No Error ME: Progress Phase : Clean Moff->Mx wake ME: Power Management Event : Non-power cycle reset ME: Progress Phase State : Unknown 0x10 ME: Extend Register not valid ME: Firmware Version 11.8.4323.93 (code) 11.8.4323.93 (recovery) 11.0.1205.0 (fitc) ME Capability: Full Network manageability : ON ME Capability: Regular Network manageability : ON ME Capability: Manageability : ON ME Capability: Small business technology : OFF ME Capability: Level III manageability : OFF ME Capability: IntelR Anti-Theft (AT) : OFF ME Capability: IntelR Capability Licensing Service (CLS) : ON ME Capability: IntelR Power Sharing Technology (MPC) : OFF ME Capability: ICC Over Clocking : OFF ME Capability: Protected Audio Video Path (PAVP) : ON ME Capability: IPV6 : ON ME Capability: KVM Remote Control (KVM) : ON ME Capability: Outbreak Containment Heuristic (OCH) : ON ME Capability: Virtual LAN (VLAN) : ON ME Capability: TLS : ON ME Capability: Wireless LAN (WLAN) : ON Bad news, you have a `Q170 Chipset LPC/eSPI Controller` so you have ME hardware on board and you can't control or disable it, continuing... Boot Guard MSR Output : 0x0 Your system isn't Boot Guard ready. You can flash other firmware! On board there is unpopulated ME_DEBUG Header which may enable Manufacturing Mode.